Air Flow Meter

COLD Air intake KIT FOR Holden commodore VE V6 (air flow meter with 2 screws)

COLD Air intake KIT FOR Holden commodore VE V6 (air flow meter with 2 screws)
COLD Air intake KIT FOR Holden commodore VE V6 (air flow meter with 2 screws)
COLD Air intake KIT FOR Holden commodore VE V6 (air flow meter with 2 screws)
COLD Air intake KIT FOR Holden commodore VE V6 (air flow meter with 2 screws)

COLD Air intake KIT FOR Holden commodore VE V6 (air flow meter with 2 screws)
RETAIL PRICE = 299.99/SET. COLD Air intake KIT FOR Holden commodore VE V6. (air flow meter with 2 screws). Cold air intake kit able to use factory maf sensor. Bolt on horsepower with large washable filter eliment. 20+ horsepower on stock vehicle. Easy to install fits VE. Remove factory air box , air intake pipe. Remove radiator mounting brackets and lay radiator toward engine.

Remove grille and disconnect wiring harness mounting tabs to allow harness to move for air box. Cut off a piece (please see photo). Fit hoses to air box and throttle body and slip air box down in front of radiator.

Note gap in front of radiator is larger on passenger side of vehicle. Slip maf sensor into hose on air box and then fit into hose on throttle body using fingers or flat blade screwdriver to fit. Fit hose clamps to both hoses and fit radiator brackets using factory grommets in supplied mounts.

Loosen maf wiring near p/s reservoir and plug into maf sensor. Fit breather hose to air box and pipe on drivers side of engine. WE WILL CONTACT BUYERS FOR MORE INFORMATION IF THERE IS ANY EXTRA CHARGES... Triple Nine Automotive (999Automotive) was established in 2003 with the goal of providing customers a one stop place for all their vehicle needs.

With more than 2000 performance products in our warehouse. We are proud to say that we will be able to cater to your requirements. At the workshop, our mechanics are trained from standard mechanical repairs to performance modifications. Including suspension upgrades and a skilled in-house fabricator for your custom requirements.

Equipped with a 4WD dynamometer from Dyno Dynamics. 999 Automotive provides aftermarket ECU tuning along with our customers being able to find out how much power their car produces in ShootOut mode.

Our aim is to make our customers' cars reliable, we want our customers to enjoy the fun of the modifications we perform to their cars. Therefore, the power figure is not the only thing we are concern about. We care for all the modifications that make your car run smooth. In addition, we offer car enthusiasts our technical experience and expertise as well as the ability to diagnose and rectify any mechanical problems of your car to perform better or run more cost efficient. Our showroom displays a wide range of products for both interior and exterior upgrades from appearance to performance.

This can be paid in Australia Dollar. We will arrange the product for you and inform you when they are ready. We are more than happy to assist you. Please ensure that you read and acknowledge the following terms and conditions prior to placing your order with TRIPLE NINE AUTOMOTIVE.

All prices and descriptions are subject to change without notice. TRIPLE NINE AUTOMOTIVE shall have the right to refuse or cancel any order placed for product listed at the incorrect price. All products on this website are intended for race or off-road use only. It is the owner's responsibility to be aware of the legalities of fitting these products in his or her state/territory regarding noise. TRIPLE NINE AUTOMOTIVE will not be liable for any special, direct, indirect, incidental or consequential damages that might be claimed as a result of the failure of any part, including claims for delay, loss of profits, or labour. TRIPLE NINE AUTOMOTIVE will not be liable for any damage or injury to persons or property resulting from improper installation or misuse of any part. TRIPLE NINE AUTOMOTIVE shall not be held accountable for any misconception or disappointment associated with any product. All goods remain the property of TRIPLE NINE AUTOMOTIVE until paid in full. It is the customer responsibility to contact TRIPLE NINE AUTOMOTIVE within this time period to be eligible for a return. It is the responsibility of the customer to verify the correct part before ordering and installing a particular part.

All foreign orders are final. The item "COLD Air intake KIT FOR Holden commodore VE V6 (air flow meter with 2 screws)" is in sale since Wednesday, July 12, 2017.

This item is in the category "Vehicle Parts & Accessories\Car & Truck Parts\Other". The seller is "999racing" and is located in 2143. This item can be shipped worldwide.

  • Manufacturer Part Number: XXXve (48137)
  • Brand: KS Racing
  • MPN: XXXve (48137)


COLD Air intake KIT FOR Holden commodore VE V6 (air flow meter with 2 screws)